10M Moxon Beam

I wanted to build a 10M beam. I looked at some of the options and decided on the Moxon after I build my 2M Moxon. I designed the Moxon using the Moxon Rectangle Generator. It is made using PVC pipe and # 14 enamel copper wire.

The main boom is made from 1 1/4" PVC Sch. 40 pipe. The ends are made from a 1 1/4" Tee, 1 1/4" X 3/4" reduceing bushings, 3/4" PVC pipe, and 3/4" 45 degree elbows. Make the end pieces first. I put the ends together and then measured where the spacing get to 55", then I cut the pipe. I then put the two ends out and measured the 150 3/4" and cut the pipe (be sure to leave enough room to slide into the Tees and still maintain the length).

End Detail

Completed Antenna

Elevation Angle

Antenna Radiation Pattern

Antenna Radiation Pattern

10M Moxon SWR